As reported in more detail at Solid State Technology, during the IEEE IITC now happening in Grenoble, imec and Lam showed a new Electroless Deposition (ELD) cobalt (Co) process that is claimed to provide void-free bottoms-up pre-filling of vias and contacts. The unit-process is intended to be integrated into flows to produce scaled interconnects for logic and DRAM ICs at the 7nm node and below. Co-incidentally at IITC this year, imec and Lam also presented on a new ELD copper (Cu) process for micron-plus-scale through-silicon vias (TSV).
The bulk resistivities of metals commonly used in IC fabrication are as follows (E-8 Ω⋅m):
Cu – 1.70,
Al – 2.74,
W – 5.3, and
Co – 5.8.
Of course, the above values for bulk materials assume minimal influence of grain sizes and boundary layers. However, in scaled on-chip interconnect structures using in today’s advanced ICs, the resistivity is dominated by grain-boundaries and interfacial materials. Consequently, the resistivity of vias in 7nm node and beyond interconnects may be similar for Cu and Co depending upon the grain-sizes and barrier layers.
The melting temperatures of these metals are as follows (°C):
Al – 660,
Cu – 1084,
Co – 1495, and
W – 3400.
With higher melting temperature compared to Cu, Co contacts/plugs would provide some of the thermal stability of W to allow for easier integration of transistors and interconnects. Seemingly, the main reason to use Co instead of W is that the latter requires CVD processing that intrinsically does not allow for bottom-up deposition.
—E.K.
